Belkin GO N300 DB Manual do Utilizador descarregar pdf (Página 7)





Your Range Extender’s status is shown by the light on the front.

Off: The Range Extender is not plugged into a power source.

 The Range Extender is starting up.

 The Range Extender is connected to the Wi-Fi

network.

 The Range Extender is connected to the

Wi-Fi network but is experiencing a weak signal. The weak

signal may be either the 2.4GHz or 5GHz band. A weak

signal may lead to performance problems. Consider moving

the Range Extender closer to the wireless router.



 The Range Extender is not connected

to the Wi-Fi network. Check to make sure that your

wireless router is functioning properly, and/or move the

Range Extender closer to the wireless router.

 The Range Extender is ready

to be set up. (Refer to “Getting Started” for instructions

on how to set up your Range Extender.)



The WPS button on the front of your Range Extender can be

used to help establish a secure connection between your Range

Extender and other WPS-enabled Wi-Fi devices such as computers.

To use the WPS feature on your Range Extender, see “Getting

Started > Adding Computers to Your Network > Using the WPS

Button.” The small light near the WPS button shows what is

happening while you are using WPS to establish a connection.

Off: Idle

The Range Extender is listening for

a WPS-enabled computer or other device.

The Range Extender has made a secure

connection with the computer or other device.

 A connection was not created.

1 2 3 4 5 6 7 8 9 10 11 12 ... 26 27

Sem comentários

Belkin GO N300 DB Manual do Utilizador Página 7