Belkin F5U022 Guia do Utilizador descarregar pdf (Página 122)

• Flow Control: XON/XOFF

To use the Pfaff creative Software with Pfaff creative embroidery machines, the following

settings were used in VIP Configure:

• ‘Pfaff 2140’ setting: COM1

• ‘Pfaff creative card station’ setting: COM1

The Pfaff creative Suite ran normally as on any other Windows platform. However, the

following was found in regard to hardware and communications:

• The Belkin USB-Serial Adapter is not recognized when the Mac is booted up from cold,

so COM1 is initially not available to Virtual PC. After booting for the first time, unplug and

reconnect the adapter, then reboot the Mac. The adapter will then be recognized

correctly by OS 9 and Virtual PC.

• All communication aspects worked correctly between VIP File Assistant and the Pfaff

creative 2140 embroidery machine.

• It was not possible to update the Pfaff creative 2140 with new firmware (this is a program

that is run directly from Windows Explorer).

• All communication worked correctly between creative Customizing and the creative card

station.

• It was not possible to establish communications with a Pfaff creative 7570 embroidery

machine. Use a creative card station to read from and write to cards for use in the 7570.

• The “USB Token” option is only be available in the USB section of Virtual PC when the

dongle is inserted into the MAC.

• Restarting the Mac with the dongle inserted gives a message that 'The software cannot

be found for USB Token'. This message is generated by OS 9, which does not use the

dongle. Click OK to close the message and carry on as normal.

N11 Why does the program sometimes ask for the CD when I run it?

To ensure you own the original program CD, a Copyright Verification Procedure will take

place at random intervals. When you are prompted to insert your program CD do so and then

you will be able to continue using your program. When you insert the CD, hold down the Shift

key for 30 seconds to prevent the Installation menu appearing.

N12 When I enter my CD for verification it is not recognized

This will happen if the drive letter of the CD has changed from when the program was

installed, such as when another drive is installed. To correct this you will need to either re-

map your drive letters or re-install the program.

Opening Designs

N14

I can't drag and drop Cross Stitch Design files from the Open dialog box

To drag and drop Cross Stitch Design Files onto the Work Area, right-click Start, then

Explore to start Windows® Explorer. Then follow the instructions under Drag and Drop in the

Loading Files chapter of the program Help.

FAQ Lists for Pfaff VIP Software Page 122

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 210 211

Sem comentários

Belkin F5U022 Guia do Utilizador Página 122