Belkin Range Extender/ Access Point Manual do Utilizador descarregar pdf (Página 13)

1110

Configuring the WURE

1110

Configuring the WURE

3.2 Click the “Refresh” button. The Utility will detect the

WURE(s) connected to your network. Select the WURE you

wish to configure.

3.3 If your WURE’s IP address is not in the same subnet as your

network, the “Set IP Address” button will be enabled. Click

the “Set IP Address” button. A pop-up screen will appear.

3.4 Set the IP address of your WURE to be within the same sub-

net as your network. For example, if your router’s IP address

is 192.168.1.1, set your WURE to 192.168.1.xx (xx would

be any number between 2–254). Be careful of duplicate IP

addresses on your network. Then set the subnet mask to be

the same as your network’s subnet mask.

3.5 Click the “UR/AP” button.

Wir eless Rang e Extend er

NOTE: If the “UR/AP” button is grayed out, click the

“Refresh” button.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 56 57

Sem comentários

Belkin Range Extender/ Access Point Manual do Utilizador Página 13