Belkin F1DN102P Manual do Utilizador descarregar pdf (Página 20)

Belkin® Advanced Secure DisplayPort KVM

COMMON ACCESS CARD (CAC) CONFIGURATION AND OPERATION

SECTIONSTable of Contents 1 2 3 4 5 6 7 85

BACK TO TABLE OF CONTENTS >

Step 1 Installation

1.1 Using the included USB cable, connect one end of the cable

to the computer that requires CAC, and the other end to the

CAC port on the Belkin Advanced Secure DisplayPort KVM that

corresponds to the computer.

1.2 Enable CAC for the same port connection in Step 1.1 by switching

the CAC switch to the right.

1.3 Repeat steps above for additional computers that require CAC.

Note: Make sure that the CAC switch is disabled (left) for all other

non-connected CAC systems.

1.4 Once configured, the CAC connection will be switched only when

required by the connected computer. When switching from a CAC

enabled port to a non-CAC enabled port, the CAC connection will

remain with the last previously selected port where the CAC was

set to enable.

CAC connection to the computer requires a separate USB cable

connection and allows the user to specify whether there is a

CAC required for that computer or not. This allows the CAC to be

connected and controlled separately to the keyboard, mouse, video

and audio.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Sem comentários

Belkin F1DN102P Manual do Utilizador Página 20