Belkin F1D102 - OmniView SE 2 Port KVM Switch Manual do Utilizador

P73039 F1D102The OmniView™SE 2-PortUser ManualP73039_F1D102-eng_man.qxd 9/26/00 3:42 PM Page 1

9The OmniView™SE is designed to be able to cascade with the OmniView™PRO as well. Insuch a scenario, it is recommended that the OmniView™PRO be the MA

10Adding Slave UnitsThis assumes you already have a MASTER unit (or MASTER and slave units) set-up andworking properly. Below is the procedure of dais

11Cable 1Cable 2Cable 3MASTER(Bank 0)slave(Bank 2)slave(Bank 3)Daisy-Chaining the OmniView™SE:slave(Bank 1)Usage (continued)P73039_F1D102-eng_man.qxd

12Keyboard “Hot” Key commands:You can also conveniently command the OmniView™SE to switch ports through simplekeyboard key sequences. To send commands

13You can switch directly to any port by giving the OmniView™SE the BANK and PORTnumbers. For instance, if you press [SCROLL LOCK] [SCROLL LOCK] [2] [

14General Problems:Q: When cascading, the MASTER unit does not see the slave unit(s).A: • Refer to the Hardware Installation section for information o

15Q: The computers boot up fine, but the mouse does not work.A: • Check the cables and make sure they are inserted properly in the correct ports.• Mak

16• Try a different PS/2 mouse at the console.• Make sure the mouse (at the console) is a true PS/2 mouse. A combo mouse will workjust as long as it i

FCC StatementDECLARATION OF CONFORMITY WITH FCC RULES FOR ELECTROMAGNETIC COMPATIBILITYWe, Belkin Components, of 501 West Walnut Street, Compton CA 90

Introduction1Thank you for purchasing the Belkin Components OmniView™SE KVM switch. Controllingmultiple PCs from one keyboard, mouse and monitor has n

2Technical SpecificationsConsole Connectors:Keyboard: 6 pin MiniDIN femaleMouse: 6 pin MiniDIN female (for PS/2 mouse)DB9 male (for spare serial mouse

3Product DetailSLAVE INPUTDB25 Daisy-chain portMASTER INPUTSLAVE OUTPUTDB25 Daisy-chain portDC power jackDIP switchesOptionalserial mouse connectorCON

4Make sure you have the right cables!The OmniView™SE requires cables to connect the eight computers you will be controlling.Below are the Belkin part

51. Set the DIP switches. If you have only one OmniView™SE, use the MASTER banksetting. If the OmniView™SE you are using will be daisy-chained off ano

6. Connect the first computer's mouse cable to the OmniView™SE. If using a PS/2 cable(Belkin Part# F2N036-XX), connect one end to the PS/2 mouse

7Hardware Installation (continued)7. Connect the first computer's keyboard cable to the OmniView™SE. If using a PS/2cable (Belkin Part# F2N036-XX

8The OmniView™SE has the capability to be daisy-chained to additional units for control overmore computers. Up to four OmniView™SE units can be daisy