Belkin F5D5230-F Manual de Instalação descarregar pdf (Página 16)

authorized library (available in the linklist or TSO/E log-on proc) with

AC=1, AMODE=31, RMODE=ANY, and NON-REENTRANT. It

must be named as a COMMAND PROCESSOR in the IKJTSOxx

member of SYS1.PARMLIB.

Customization

The following changes to default behaviour may be made if desired,

and must be done before assembling the program.

Message options

The defaults for message and data display can be changed by modifying

the value specified in the DEFAULT= parameter on the IKJKEYWD

macros labelled KLIST (for data display) and KMSG (for data and

messages).

Authorization

A System Special RACF user is normally allowed to perform any

operation by the program, but you can disable this if required by

uncommenting the instruction labelled SPECHK in subroutine

SAUTHCHK and uncommenting the MNOTE that immediately

follows it. To re-enable, simply comment out these two instructions

again.

Field name Field length Field contents

The following fields occur once and constitute the ‘header’:

usrcntl * 4 Length of USRCNT field (always=4)

USRCNT 4 Number of occurrences following

usrdlen * 4 Total length of ALL occurrences following

The following fields are repeated once for each occurrence:

usrdocl * 4 Length of this occurrence

usrnml * 4 Length of USRNM field (always=8)

USRNM 8 Name of occurrence (installation defined)

usrdatal * 4 Length of USRDATA field (1-255)

USRDATA 1 to 255 Installation supplied data

usrflgl * 4 Length of USRFLG field (always=1)

USRFLG 1 Installation supplied value (0-255)

* Field names in lower case are used in MCINTY only and not defined in the

RACF templates.

Figure 2: Data returned by an ICHEINTY request

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 114 115

Sem comentários

Belkin F5D5230-F Manual de Instalação Página 16