Belkin F5D5230-F Manual de Instalação descarregar pdf (Página 20)

REFERENCES

• OS/390 V2R8.0 Security Server (RACF) Macros and Interfaces

– ICHEINTY interface and return codes

– RACF database templates and field definitions

– Userdata, repeat groups, and combination fields.

• OS/390 V2R8.0 Security Server (RACF) Security Administrator’s

Guide

– Field-level access checking.

• OS/390: TSO/E Programming Services

– Using the variable access routine IKJCT441

– Miscellaneous TSO/E services.

MCI09E: ESTAE SETUP FAILED RC=nnn

Error (0) – Set-up of the program’s recovery environment failed with the

ESTAE return code shown. The program will continue without its internal

recovery routine.

Action – Notify the systems programmer.

MCI10E: FIELD SPECIFICATION ERROR – fieldname

Error (12) – The field named was returned with more than 255 characters,

which is the maximum that the program supports.

Action – This can be caused by a command line parameter conflict. If the

RGROUP parameter is erroneously specified for a non-repeat-group field, or

NORGROUP for a repeat-group field, this error will occur. Correct the

parameters. The RGROUP/ NORGROUP parameters aren’t usually required.

MCI99E: ABEND Sxxx PICyy AT +offset PSW psw

Error (16) – An internal abend occurred and was trapped. The message

shows the system completion code (xxx), the program interrupt code (yy), the

offset, and the psw at the time of the error. If the abend is outside the program

the offset is omitted.

Action – To get more information about the error use the DEBUG parameter

to disable the ESTAE.

Figure 4 (part three): Messages, errors, and actions (continued)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 114 115

Sem comentários

Belkin F5D5230-F Manual de Instalação Página 20