
© Copyright 2006 Autonomic Controls, Inc.
- 5 -
Revision 1, Build 1171 www.autonomichome.com
© Copyright 2006 Autonomic Controls, Inc
Making the connection
The HAI panel can be connected to the Media Center computer using one of two methods:
1. Serial Connection: Using the HAI provided RJ-11 to DB-9 adapter, connect an open
9 pin serial port on the Media Center Computer to an open RJ-11 serial connection on
the HAI OMNI main or serial expansion board.
2. USB Connection: Using the RJ-11 to DB-9 adaptor and a USB to Serial adapter,
connect an open USB port on the Media Center Computer to an open RJ-11 serial
connection on the HAI OMNI main or serial expansion board.
Configuring the HAI Omni.
The built-in serial ports (J1-J3) on the controller are assigned to Serial Port 1 - Serial Port 3,
respectively. Serial port 4 is a Serial Interface Module connected to the Expansion port on the
controller.
The serial port used on the Omni must be set to use the “Pro-link” protocol. This can be
configured on the HAI using the Omni keypads, or by using the HAI PC Access Software as
illustrated below.
Comentários a estes Manuais